xC00005 MOREZMORE HPA-M3 CAVE EXPLORER Humanly Posable Armature STARTER Puppet Kit

(No reviews yet) Write a Review

Out of stock

Northern wing of the estate.
A stone-paved path leads to Morezmore Studio.
Inside you find:

Humanly Posable Armature
HPA-M3 CAVE EXPLORER Humanly Posable Armature HARDWARE Puppet Kit for an articulated doll or stop motion puppet

Height - 12" (30.5 cm)
Includes hardware and all the necessary tools.

Humanly Posable Armature General Info and Instructions
For successful completion of your armature, you will need these tools (see the photo just below). THIS KIT INCLUDES THESE TOOLS.
But you might have these tools already.
If you have them, please consider Hardware Only Kit (C00004), which includes only the hardware.

You can also purchase all tools and additional hardware parts SEPARATELY

2015-06-29 09.27.27

What is included:

M3x8mm threaded balls (half thread) 8
M3x6mm threaded balls (full thread) 20
M3 chest bar 1
1/8" Jeton inch 2
3/32" Jeton inch 2
M2x5mm brass connectors 4
35 mm nylon standoff 2
20 mm nylon standoff 6
foot pad 2
M3 cube 1
1/8″x30mm square brass tubes 3
5/32″x30mm square brass tubes 4
1/8″x15mm square brass tubes 1
M3x16mm threaded rods 24
M2x10mm brass connectors 10
10 mm nylon standoff 2
 joint compression plates 28
M3 hex nuts 17
M2x10mm button hex screws 14
M3x10mm threaded rods 8
M3x20mm threaded rods 1
M3 T-nuts 3
L-shaped threaded rod M3*80 2
2 pieces M3 wing nuts 2
pipe cleaners 5
1 piece of allen hex key (for assembly) 1
1 oz of Instamorph moldable thermoplastic 1
clear plastic 10-compartment boxes to hold the small parts 2
2 pieces long nose pliers (to tighten screws) 2
1 pack of JB Cold Weld Steel Reinforced Epoxy (thread lock) 1

All parts, tools and materials can be purchased SEPARATELY.