A stone-paved path leads to Morezmore Studio.
Inside you find:
Humanly Posable Armature
HPA-2R SIMPLE Hardware Kit
for an articulated doll or stop motion puppet
Includes Hardware ONLY
Humanly Posable Armature General Info and Instructions
This kit includes only hardware.
For successful completion of your armature, you will need these tools (see the photo just below). THIS KIT DOES NOT INCLUDE THESE TOOLS.
You might have these tools already, but if you don't have them, please consider HPA-2R Starter Kit (M00272), which includes both this hardware and all the necessary tools.
You can also purchase all tools and additional hardware parts SEPARATELY.
What is included:
The hardware that is included in this kit is enough for 1 puppet.
26 pieces joint compression plates (plates for joints)
2 pieces chest/hip connectors (for chest and hip connections)
14 pieces M2x10mm button hex screws (joint middle screws)
2 piece of M2x20mm brass connector (tension regulator)
13 pieces M2x5mm brass connectors (tension regulators)
2 pieces 16mm M2 threaded rods (for spine barbell)
3 pieces M2 threaded 6 mm steel balls (full thread)
23 pieces ball screws (for joints)
3 pieces M2 hex nuts (1 for neck joint, 2 for ankle joints)
24" piece of 1mm annealed aluminum wire (to make finger armature)
3 pieces of 30 mm cut tubes 5/32 inch (1 for head removable module, 2 for arms removable modules)
2 pieces of 40 mm cut tubes 5/32 inch (for leg removable modules)
15 pieces of M2x10mm brass connectors (for limb connecting, for joint regulators)
1 piece of allen hex key (for assembly)
1 piece of perforated steel slice (for sitting bone)
2 pieces of clear plastic 10-compartment boxes to hold the small parts
All parts, tools and materials can be purchased SEPARATELY.