A stone-paved path leads to Morezmore Studio.
Inside you find:
Humanly Posable Armature
HPA-M2R Starter Kit
for an articulated doll or stop motion puppet
Includes Hardware and Tools
Humanly Posable Armature General Info and Instructions
For successful completion of your armature, you will need these tools (see the photo just below). THIS KIT INCLUDES THESE TOOLS.
But you might have these tools already.
If you have them, please consider HPA-M2R Hardware Only Kit (M01141), which includes only the hardware.
You can also purchase all tools and additional hardware parts SEPARATELY.
What is included:
The hardware that is included in this kit is enough for 1 puppet.
26 pieces joint compression plates
2 pieces chest/hip connectors
24 pieces M2 threaded 6 mm steel balls (full thread)
12 pieces M2x16mm threaded rods
4 pieces M2x30mm threaded rods
2 pieces M2x50mm threaded rods
2 pieces ball screws
14 pieces M2x10mm button hex screws
11 pieces of M2x10mm brass connectors
2 piece of M2x20mm brass connector
23 pieces M2x5mm brass connectors
3 pieces of 30 mm cut tubes 5/32 inch
2 pieces of 40 mm cut tubes 5/32 inch
3 pieces M2 hex nuts
24 inch piece of 1mm annealed aluminum wire
1 piece of allen hex key (for assembly)
1 piece of perforated steel slice (for sitting bone)
2 pieces of clear plastic 10-compartment boxes to hold the small parts
Must Have Tools: (things you buy once).
2 pieces long nose pliers (to tighten screws)
1 pack of JB Cold Weld Steel Reinforced Epoxy (thread lock)
All parts, tools and materials can be purchased SEPARATELY.