M01293 MOREZMORE Sculpting Head Armature Stand LARGE 1:2 3/4 1:1 LIFE-SIZE

Was: $19.80
Now: $19.21
(No reviews yet) Write a Review

Northern wing of the estate.
A stone-paved path leads to Morezmore Studio.
Inside you find:

a Sculpting Head and Bust Armature Stand
Non-rotating, static

Adjustable bottom wheel height for holding the head armature vertically hands-free while you are sculpting a head Size: Large (for 1:2, 3:4, 1:1 Life-size)

How to:
Put a ball of crumpled paper around the top wooden knob (The wooden knob rotates freely.)
Secure the paper ball with tape, so that it does not fall off.
Put the clay around the ball and sculpt.
Instead of the wooden knob you can use anything you can mount on 1/4 inch thread - aluminum foil ball, plastic ball, paper ball, wooden beads, your own clay balls.

Vertical Rod Height: 12" (30 cm)
Wooden Knob Diameter is 25 mm.
Thread: 1/4 inch
Base Diameter: 7 or 8" (17 or 20 cm)
Base Thickness: 3/4" (1.9 cm)

- Sturdy simple steel wood construction
- Adjustable head height, will work for 1:2, 3:4, 1:1 (life-size) scales
- Non-rotating round wooden 8" base
- Easy 2-step assembly - no tools required.
- Soft felt feet - will not scratch your sculpting table
- You can screw it and unscrew it as many times as you need for sculpting, baking (if polymer clay), etc.
- Once you complete your head sculpture, you will be able to remove it from the threaded rod, just like you would remove a knob from a desk drawer.

- Vertical threaded rod (1/4" thread)
- Wooden base
- 2 Wing nuts
- 1 Hex nut
- 1 T-nut in the bottom of the base
- 1 Washer
- 1 Wooden knob (5/16 hole)

Will be shipped flat, minor assembly required (screwing the vertical rod into the the hole in the base).

1. Insert the vertical rod into the threaded hole in the base.
2. Tighten the wing nut (on top of the base), this will secure the rod in the T-nut (which is inside the base).