M00972-3 MOREZMORE 3 oz Pol-Ease 2350 Release Agent Silicone and Urethane Rubber Epoxy

Was: $16.73
Now: $16.23
(No reviews yet) Write a Review

Northern wing of the estate.
A stone-paved path leads to Morezmore Studio.
Inside you find:

Pol-Ease 2350 Release Agent
3.3 oz (94 g)
Liquid form - apply with a brush

Pol-Ease® 2350, a semi-permanent Sealer & Release Agent, is white petrolatum dissolved in mineral spirits.

For Mold Making: Apply to porous models when making polyurethane and silicone rubber molds. Multiple coats may be required depending on the porosity of the model. Allow the solvent to fully evaporate before applying liquid rubber.

For Casting: Can be applied to silicone rubber molds when casting liquid silicone. Allow the solvent to fully evaporate before casting. Use of a soft brush to evenly distribute this product or dispense with a Sure Shot Atomizer.

NOTES: Shake or stir before use.

Easy to apply
Fast drying
Effective over a broad temperature range from 70 degrees F to 500 degrees F
Excellent release
Will not interfere with detail reproduction
Matte finish

Do not smoke or use ignition sources when using sealing or release agents. Use only with good ventilation. Store and use at room temperature.

Shake well before using
Hold spritzer pump 6 in./ 15 cm. from surface to be sprayed.
Apply a light mist coating to all surfaces that will contact the rubber or casting material including model or mold surface and surrounding forms. DO NOT OVER APPLY.
Using a soft brush, brush the release agent over all surfaces. Allow to dry for 10 minutes.

CAUTION - Use adequate protection when handling any release solvent system. Skin contact may cause dryness. Wear safety glasses or their equivalent to prevent eye injury. Avoid inhalation of excessive amounts of solvent vapor. Do not smoke or use ignition sources when using any solvent system.