M01207 MOREZMORE Try Ease Release 205 Agent Silicone and Urethane Rubber Epoxy

Was: $3.15
Now: $3.06
(No reviews yet) Write a Review
SKU:
M01207
Northern wing of the estate.
A stone-paved path leads to Morezmore Studio.
Inside you find:

Sample of Ease Release 205
0.75 oz (21 g)
Liquid form - apply with a brush

EASE RELEASE 205 is a versatile liquid release agent that is used for a variety mold making and casting applications. This product will release liquid urethane rubber from cured urethane rubber and a variety of surfaces. It will also release silicone rubber from itself and a variety of surfaces.

ER 205 can also be used to release epoxy, and urethane resins as well as thermoplastics. EASE RELEASE 205 is effective on a variety of substrates including steel, aluminum, chrome, epoxy, urethane rubber and plastics, sealed plasters, sealed concrete and wax.
Features

Easy to apply
Fast drying
Effective over a broad temperature range from 70 degrees F to 500 degrees F
Excellent release
Will not interfere with detail reproduction
Matte finish

Instructions

Model Preparation if making molds using urethane or silicone rubber, the model surface may need to be sealed (using a sealing agent) before applying release agent. Read the technical bulletin for the mold rubber you are using before proceeding.

APPLYING EASE RELEASE 205 Do not smoke or use ignition sources when using sealing or release agents. Use only with good ventilation. Store and use at room temperature.

Shake well before using
Hold spritzer pump 6 in./ 15 cm. from surface to be sprayed.
Apply a light mist coating to all surfaces that will contact the rubber or casting material including model or mold surface and surrounding forms. DO NOT OVER APPLY.
Using a soft brush, brush the release agent over all surfaces. Allow to dry for 10 minutes.

Important - this product has a limited shelf life and should be used as soon as possible.

CAUTION - Use adequate protection when handling any release solvent system. Skin contact may cause dryness. Wear safety glasses or their equivalent to prevent eye injury. Avoid inhalation of excessive amounts of solvent vapor. Do not smoke or use ignition sources when using any solvent system. Always consult Material Safety Data Sheet before using any sealer or release agent.
[]